How To Fix An Oil Tanker


What People Say

Photos

big oil tanker repair
stock photo : Big oil tanker,
How To Fix An Oil Tanker
You sink the Super Oil Tanker
More Photos

Video

Over the years, the technology of transporting oil has changed. Oil is one of the biggest industries right now in terms of demand and one of the products almost all countries are dependent to. An oil tanker is a sea vessel specifically designed for the transport of bulk oil products, it is also known as a petroleum tanker. There are two types of oil tanker, the product tanker and the crude tanker. A lot of oil tanker related accidents have had killed the lives of many ship workers and the worst would be an oil spill which can damage our oceans and its resources. Please see below some steps and tips on how to fix an oil tanker.  We suggest you get professional or psychological help before you attempt these steps.

How To / Instruction

Difficulty: Normal

  • Step

    1

    One way to stop the oil leak is to insert a long heavy rod into straight into the well shaft, another way would be to try to lodge the rod in the pipe as an obstacle using explosives and spines. Example a 100 foot rod is inserted into the pipe, then put the flush with the rod some explosives spines that are connected to the rod.

  • Step

    2

    The spines could be connected to the rod itself or connected by cables. If cables are to be to be used, you should make a small net of integrated cables to catch debris coming up from the bottom.

  • Step

    3

    You should use two sites of explosives, one at the center and one near the top of the rod. in order to drive the rods into the well casing walls you must set the explosions off together.

  • Step

    4

    One should be a nautical or marine engineering graduate to be able to learn the basics on how to fix an oil tanker. A lot of simulation trainings will be done at school and extensive training will be provided in the ship.

  • Step

    5

    After the explosions have been done, place some knobby bulb shapes, or grappling hooks on the spine ends to help anchor the spines into the wall

  • Step

    6

    Build into the bottom half of the rod some positive buoyancy materials that can detach. There should be about 200 pieces materials that are buoyant so that can get caught by the cable webbing and also the anchor spines. Connect some of the buoyant pieces together with short cables to help them catch the netting above.

  • Step

    7

    Move along some detonation cord down across the buoyant materials to just make sure they separate at the time of the explosion. When the explosion has been done and went off already, the rod gets pinned securely to the walls and the netting deploys. The buoyant pieces goes up with the rising oil and get stuck opposite the webbing so the leaking oil may become completely blocked as a result.

Tips and Warnings

  • Be careful with what you do and make sure that you have enough knowledge on fixing an oil tanker. The odds are you do not have the level of expertise to complete such as task if you are coming to binarybits.com for the answer.

  • You need to learn how it works and how to deal with congress because they will subpoena you. Also good communication with the media is key. You don't want to be seen as the bad guy.

  • Use necessary gears and equipment to keep you protected.

  • Do not smoke while doing this.

Comments